Downloaded software and bought components using the hackster.io page. So excite for this.
Before i spend a ton of time printing i typically setup my electronic equipment in a dummy setup to make sure all the electrical bits and parts work. Its not pretty but I did manage to wire up the pi, stepper shield, IMU, switch, motor and sweep.
So here's the problem (maybe its not, i don't know). I am able to load the img to the PI, works on my Iphone. I am able to test the limit switch and motor. The limit switch when depressed will show pressed. The motor when told to move 90 degrees moves 90 degrees, I have to depress the limit switch to pretend it turned, but it works.
When I test the sweep motor . . . it just says device is adjusting . . . and sits there. Does this take a long time?
Finally i hit the scan button, default settings, and it says resetting device, then it says adjusting to device settings and just sits there. . . so i have a problem?
BTW my sweep is a v1.0 serial 803.